hi, if the value is .001, I can put <.01 in the table
now I'm not sure about negative values
what about -.06? would this also be <.01?

thanks very much
love satchi

I'd put <.01 for .001 but -.06 is to two decimal places so I would put this instead of <0.01.

I hope that is clear. I'm struggling to make this sentence make sense for some reason (lack of tea probably!)

Satchi, if this is for your thesis then keep the actual values in if they are p values - then you can go through and change later if necessary. I've had journals wanting actual P values rather than < than values. if that makes sense!

thank you so much!
I can see it clearer now :-)
I was confused over positive and negative.

thanks again
love satchi

Why not just set all numbers to 3 d.p. ?